IP Configuration - set to manual and assign a static IP and netmask. Configuring HP ProCurve switches to use CLI instead of text-based menu Switch Ports The switch has 24 auto-sensing 10/100/1000Base-T RJ-45 ports. By default, user names and passwords sent to the HP Procurve devices are masked from the authentication logs when using 6.x or later. 4 Safety; 5 Contents. If you encounter authentication failures: 1. Fig 1 shows the Setup screen with the default settings. Your ProCurve will now enter the CLI when logging in with SSH or Telnet and Auvik. Enable SSH version 2 if supported. IMPORTANT: The Procurve must have an IP . Configuring HP ProCurve Network Switch - Random Bio 14 Figure 1-3.Front of the HP ProCurve 3500-24-PoESwitch HPE Support Center When all three mode LEDs (Act, FDx, and Spd) begin to blink, release the Clear button. 2. Click on [Apply Changes] to activate the user names and passwords. Enable SSH version 2 if supported. On the Inventory page, locate the HP Procure device. Hewlett-Packard assumes no responsibility for the use or reliability of its software on equipment that is not furnished by Hewlett-Packard. Returning the configuration of these features to their Factory reset HP Procurve 1810-24G (J9803A) to default settings From the factory the switch will have the following IP address; 192.168.2.10 (255.255.255.0). Guide de Configuration - HP Procurve - Switch | Networklab As soon as the Test LED begins to flash, release the Clear button. Quelques rapides explications seront données. You add a named . In the factory default configuration, the default IP address of the HP ProCurve Switch Series 1800 and 1810 is 192.168.2.10 and the subnet mask is 255.255.255.. Two of these 3. Posted: Tue Jan 31, 2017 11:54 pm. HP 2910AL User Manual - ManualMachine.com 1 Introducing the Switch; 2 Installing the Switch; If you're connecting via SSH, you should get a prompt "Login as" but Enter will bypass that and give you access to the switch in config mode.